I can publish further, the message says that ‘it is a known error, when publishing again the action will be ignored.’ I get two screens, one with the explicit errorcode, and one somewhat later on mentioning all the pages where thet error occurs.
Reset the Action(s) and try again, and this time, make a screenshot of each error screen that appears. (Shift - Command - 4 gets you a crosshairs cursor, draw the box around the error screen, and when you release the mouse, you will get a grab of just the area inside your marquee.)
The second error about it being a known error means that Freeway has marked the Action as having an internal error, and is excluding it from the publish process. This is why you are able to continue publishing. You will need to go through the page, click on each element that has an Action on it (and the page itself) and if you see a button labeled something like “reset Action” or “clear error” (can’t recall what it says off-hand) then press it. You will need to look at all the tabs in your Action palette on each element that has an Action applied. Once you have everything cleared back to the normal starting point (so all of the Actions will try to run during the publish) then publish and copy each error as it hits.
Post those screenshots on a Web site somewhere, or an image-sharing service like ImageShack or the like. Paste a URL to each image here, and we can look at what is going on in your document.
Walter
On Jul 17, 2012, at 1:09 PM, atelier wrote:
I can publish further, the message says that ‘it is a known error, when publishing again the action will be ignored.’ I get two screens, one with the explicit errorcode, and one somewhat later on mentioning all the pages where thet error occurs.
Hmmm. Can you please send me (off-list, maybe through Fling!) a copy of the EE Action for dissection? I know what my Action is doing in that spot, but I don’t understand what EE may be doing to make that simple operation fail.
Haven’t got it. Remember, if you use Fling, I don’t get notified unless you click the “send an email” link. The file just goes into S3 and nobody knows about it.
Walter
On Jul 17, 2012, at 4:42 PM, atelier wrote:
Walther, I’ve send you the action, and a screenshot with my set-up of the FW document. Hope this helps.
OK, I was absolutely not aware of that, since the sending succeeded, in july.
I try again, this evening. Do hope youbfind a solution. The EE resourses action changes paths, as far as I understand.